This site uses cookies to ensure you the best experience on our website.
By continuing to navigate through this site or by clicking Accept, you consent to the use of cookies as described in our privacy policy.    

Short Radius, 90° Fitting

NOTE: Use the Fittings Calculator to determine total amount of hardware required for your fittings.

To form 90° bends in the tray, cut the wires shown in the color shaded area of the drawing which corresponds to the width of the tray used.

1 CUT THE BOTTOM AND SIDE WIRES
Bends can be formed easily on-site by cutting the bottom and side wires. T he shaded areas indicated should be cut and removed. Then, simply bend Unistrut wire basket tray to form a 90° angle and you are ready to install. Make sure you use the appropriate hardware.

2 ASSEMBLE USING APPROPRIATE HARDWARE

Standard use is:

  • Sizes 100mm - 300mm (1 pc) AF-KITCH1

  • Sizes 400mm - 600mm (2 pc) AF-KITCH1

NOTE: Always place nut on outside of tray
90° Bends - Cutting Diagrams